Hub Connection Tool
The Hub Connection Tool creates a connection line that can receive connections and is typically used for creating network diagrams. The connection line can originate from any side of the source figure and connects to any side of the target figure or to another hub connection line.
To select the Hub Connection Tool, complete the following steps:
-
Click on the Hub Connection Tool option within the Connection Type Tab in the Sidebar.
-
Click on the Connection Tool within the Drawing Toolbar.
This connection between the figures is created in the same manner as with the Line Connection Tool; however, the connection path can be placed between two hub connection lines to create a networking or alternative type of diagram.
Perform a Click/Drag combination from the desired starting point on the source figure to the desired end point on the target figure or hub connection line and then release the Click action to complete the connection.
The selected figures or hub connection lines will be highlighted in blue when a valid connection has been made. Refer to the images below to see a hub connection between figures:
The completed connection line will appear as below.
The following example shows a hub connection line joining two previously drawn hub connection lines.
Note: Performing a Click/Drag combination on the second figure after the connection is established results in the connection line position being adapted to keep the two figures connected.